Mastercard and Replacement NFC Cards for Aerocarbon Mobility Scooter

Mastercard and Replacement NFC Cards for Aerocarbon Mobility Scooter. You will receive 1 x Mastercard for pairing and 2 x NFC cards.

You will need the master card, the NFC user card you want to pair, and a charged scooter battery. The scooter must be switched off before you start.

The NFC reader is on the tiller or display area of the scooter. This is the same place you normally tap a card to turn the scooter on.

To enter programming mode, make sure the scooter is off. Hold the master card against the NFC reader and keep it there for about five to ten seconds. The scooter may beep, the display may flash, or the scooter may briefly power on. This indicates it is now in pairing or programming mode.

Once in programming mode, remove the master card. Within about ten seconds, tap the NFC user card you want to add against the NFC reader. Wait for a beep, light, or display response. This confirms the card has been paired.

If you have more than one NFC user card to add, repeat the same step for each card while the scooter remains in programming mode.

To exit programming mode, tap the master card on the reader again, or leave the scooter untouched for around ten to fifteen seconds. The scooter should then exit programming mode automatically.

To test, switch the scooter off and then tap one of the newly paired NFC cards. The scooter should power on normally if pairing was successful.

Mastercard and Replacement NFC Cards for Aerocarbon Mobility Scooter part is exempt from VAT if it is purchased by the disabled user themselves. If a dealer or professional purchases this vat is applied.

If you are unsure where to find the serial number, or unsure if this is the right part for your Mobility scooter, please call one of our team on 01843 292136 or click here to contact us.

Please note: Picture is for illustration purposes only

For all your Mobility needs visit First Choice Mobility Ltd,  Instore  -  Online  -  Mobile